Nissan Steering Wheel Control Interface
Retain the original steering wheel remote control functions,
if you trade in your factory radio for an aftermarket radio.
Compare the illustrated connector of the adapter with
that in your car to make sure you have the right one.
Also check if any of the
specified original factory radio is installed in your vehicle!
Notes:
CAN bus
Connection: 20 pin / 24 pin Nissan connector
Connection: OEM antenna > DIN(m) / blue +12V antenna remote control
Connection: OEM AUX > Cinch(m) red/white
Connection: OEM USB > USB-A
Connection: OEM 360° camera system > Cinch(m) yellow
Vehicles with OEM navigation
Vehicles with 360° camera system
Vehicles with N-Connecta equipment
Vehicles with N-Vision equipment
Vehicles with Tekna equipment > Nissan Savety Shield not supported
Motion detection
Parking assistant
Drowsiness detection
Blind Spot Assist
Date/Time Settings > FIS in AUX position
FIS Reset Factory Settings and Reconfiguration Required if AUX Menu Option Missing
Track forward / Track back > Function can be reversed
Suitable for the following vehicles:
Nissan Juke (F15) 10/2010 - 06/2014
Nissan Juke (F15) 06/2014 - 11/2019
The following signals are provided:
Re-imported vehicles or vehicles with different software may be functionally incompatible.
red: +12V ignition terminal 15
orange: +12V lighting terminal 58
purple/white: +12V reverse signal
pink: speed signal
green: ground GND handbrake signal
Total output load: 100 mA max.
Current requirement greater than 100 mA:
1 relay Coil resistance 75 Ohm min.
2 relays Coil resistance 150 Ohm min.
Steering wheel remote control
Supported date/time settings
360° OEM camera system supported
Connection cable for the following radio manufacturers:
Suitable for: Nissan Juke 2010-2019